Showing 1–12 of 20 results

$38.50

IP65 plug to suit Sevcon Gen 4 controllers. Includes 25 tin plated copper alloy contact pins.

$95.70

Water Pump specifically designed for Cooling EV Motors, Controllers and Chargers.

$156.20

NOTE: DUE TO COVID-19 WE HAVE HAD TO TEMPORARILY SUBSTITUTE HBD41AB (BLACK SWITCH) INTO STOCK. GIGAVAC manual disconnect switches provide a level of sealed switching technology to meet any DC application requirement. 1000V 400A Isolator Switch, single pole, single throw.

Contactors

Gigavac GX14

$201.30

When quality and reliability  are essential there is only one choice, Gigavac. Similar in design but different form factor to GX23BA. Designed specifically for high voltage DC applications this contactor is a drop-in alternative to Tyco/Kilovac* 500+ Amp EV200. Most cheaper contactors are rated only to 80VDC. Above this they cannot operate safely.

Contactors

Gigavac GV200PA

$206.80

500+ Amp 12-800VDC This Gigavac contactor is designed to switch up to 800VDC. Suitable for use with Sevcon Gen4 Size 2,4, and 6 controllers due to non economiser coil.

$341.00

Sevcon DC/DC Converters are suitable for all electric powered vehicles and are designed to be fitted on-board and connected permanently to the traction battery.  These fully encapsulated converters deliver a stable isolated high power, low voltage DC supply for accessories such as lights, horns, and wipers. Unparalleled reliability.

Out of stock
$616.00

Clearview is a configurable CANopen colour display which can be set up to show a variety of information sent from the Sevcon motor controllers it is connected to. It can also be used to configure parameters on the controllers.

$716.10$876.70

The Gen4 range represents a well established design in compact AC controllers. These reliable controllers are intended for on-road and off-road electric vehicles and feature the smallest size in the industry for their power capacity. Thanks to the high efficiency it is possible to integrate these controllers into very tight spaces without sacrificing performance. The design has been optimised for the lowest possible installed cost while maintaining superior reliability in the most demanding applications.

$748.00

Motenergy Motor Dual Stator PMAC (brushless) DC motor for traction and pumping applications.

Permanent Magnet AC motor designed specifically to suit the 24-48V Sevcon controller range. Regenerative braking is a feature of all PMAC motors. Uses Sin/Cos rotor position sensing, the latest technology for ultra smooth starting. Motor is Radial flux.

$869.00

Motenergy Motor Dual Stator PMAC (brushless) DC motor for traction and pumping applications.

Permanent Magnet AC motor designed specifically to suit the 48-80V Sevcon controller range. Regenerative braking is a feature of all PMAC motors. Uses Sin/Cos rotor position sensing, the latest technology for ultra smooth starting. Motor is axial flux with one rotor between two stators.

$902.00

Output Power of 12 KW Continuous, 30 KW Peak (at 96 volts) Designed for long life. No brush maintenance. The motor is 92% efficient at voltages between 24 to 96 VDC. Continuous current of 150 Amps. This is a 3-phase, Y-connected Permanent Magnet Synchronous Motor with an axial air gap and Sine/Cosine Speed Sensor. It has two stators with a rotor in the center.

$958.10$1,437.70

The Gen4 range represents a well established design in compact AC controllers. These reliable controllers are intended for on-road and off-road electric vehicles and feature the smallest size in the industry for their power capacity. Thanks to the high efficiency it is possible to integrate these controllers into very tight spaces without sacrificing performance. The design has been optimised for the lowest possible installed cost while maintaining superior reliability in the most demanding applications.